Standard Prep Undercounter Refrigerator - 2 Drawers

Dont waste time walking to the refrigerator for your ingredients.
Instead have all your vegetables, meats and other condiments right in front of you.
Delfield 4400 Series units are front breathing, which allows the unit to be pushed right against a wall, built into a cabinet or an existing line-up.
Each unit has virtually unlimited top pan configurations to allow you versatility to change your menu without adding extra cost.
In addition, you dont have to worry about leaving your condiments out all day.
All Delfield 4400 Series prep systems are designed to maintain 33-41 in 100F weather and 70% humidity.
NSF-7 requirements only require product to maintain temperature in 86F and 50% humidity.

• Exterior top is one-piece, 22-gauge stainless steel with integral 2.12 (5.1cm) square nosing on the front.
• Exterior back and bottom are two-piece 24-gauge galvanized steel.
• Exterior ends are stainless steel.
• Interior sides of door models are thermoformed ABS plastic with integral shelf supports.
• Base is fully insulated with high-density foamed in place polyurethane.
• Refrigeration system uses HFC-404A refrigerant.
• Compressor is 1/5 H.P., with condenser coil and condensate evaporator mounted on rear of the cabinet.
• Evaporator coil and temperature control are located on the interior rear wall of the cabinet.
• Refrigerant flow is controlled by a capillary tube.
• Cabinet maintains an interior cabinet temperature of 36° F to 40° F (2° C to 4° C).
• Electrical connections are 115 volt, 60 Hertz, single phase.
• Unit has an 8 (2.4m) long electrical cord and NEMA 5-15P plug.
• Casters: Equipment is mounted on 2 (5.08cm) diameter front locking plate casters.
• Equipment clearance above the floor is 2.5 (6.35cm).
• Doors have a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner.
• Cabinet of door models has one adjustable epoxy-coated wire shelf.
• Drawers have a 22-gauge stainless steel exterior with thermoformed ABS plastic interior liner.
• Drawer frames and slides are 14-gauge stainless steel, with stainless steel bearings.
• Drawer units have three drawers.
• Each drawer holds one 12 x 20 x 4 deep (30.5cm x 50.8cm x 10.1cm) pan, supplied by others.
• Dimensions: 27" x 31.5" x 34.25"

Optional Accessories and Modifications
• 18 wide single tier overshelf
• Plastic laminate on front
• Additional wire shelves
• Door lock
• 36 height available for UC
• *220V/50 Hertz electrical system

* Inclusion of this option will alter electrical specifications of the unit.

*****Image Displays Similar Item Only. Product has 2 Drawers******