Standard Prep Double Door Undercounter Refrigerator - 48''

Dont waste time walking to the refrigerator for your ingredients.
Instead have all your vegetables, meats and other condiments right in front of you.
Delfield 4400 Series units are front breathing, which allows the unit to be pushed right against a wall, built into a cabinet or an existing line-up.
Each unit has virtually unlimited top pan configurations to allow you versatility to change your menu without adding extra cost.
In addition, you dont have to worry about leaving your condiments out all day.
All Delfield 4400 Series prep systems are designed to maintain 33-41 in 100F weather and 70% humidity.
NSF-7 requirements only require product to maintain temperature in 86F and 50% humidity.

Exterior top is one-piece 22-gauge stainless steel with integral 2.12 (5.1cm) square nosing at the front.
Exterior back and bottom are two-piece 24-gauge galvanized steel.
Exterior ends are stainless steel.
Interior sides are thermoformed ABS plastic with integral shelf supports.
Base is fully insulated with high-density foamed in place polyurethane.
Refrigeration system uses HFC-404A refrigerant.
Compressor is 1/4 H.P., with condenser coil and condensate evaporator mounted on rear of the cabinet.
Evaporator coil and temperature control are located on the interior rear wall of the cabinet.
Refrigerant flow is controlled by a capillary tube.
Cabinet maintains an interior cabinet temperature of 36°F to 40°F (2°C to 4°C).
Electrical connection is 115 volt, 60 Hertz, single phase.
Unit has an 8 (2.4m) long electrical cord and NEMA 5-15P plug.
Casters: Equipment is mounted on 2 (5.08cm) diameter plate casters with front two locking.
Equipment clearance above the floor is 2.5 (6.35cm).
Doors have a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner.
Cabinet is supplied with one adjustable epoxy-coated wire shelf per door opening.
Drawers have 22-gauge stainless steel exterior with thermoformed ABS plastic interior liner.
Drawer frames are 14-gauge stainless steel.
Drawer slides are 14-gauge stainless steel with stainless steel bearings.
Each top drawer holds one 12 x 20 (30.5cm x 50.8cm) pan 4 -6 (10.1cm-15.2cm) deep.
Each bottom drawer holds one 12 x 20 (30.5cm x 50.8cm) pan 4 (10.1cm) deep.
Pans are supplied by others.
Dimensions: 48" x 31.5" x 34.25"

Optional Accessories and Modifications
• 2 x 4 high stainless steel backsplash
• 18 wide single tier overshelf
• Plastic laminate on front
• Additional wire shelves
• Door lock
• 36 height available on UC model
• *220V/50 Hertz electrical system

* Inclusion of this option will alter electrical specifications of the unit.