Stand-Outs™ Wire Shelving - 21

Stand-Outs™ Wire Shelving with Red Epoxy Finish

• 21"W x 48"L
• 4 shelves per case.
• Wire shelf, constructed of carbon steel or type 304 S/S wire, consists of a top mat assembly using 10 gauge (.135" diameter) mat wires spaced on 7⁄8" centers and welded to full length 6 gauge (.187" diameter) inside support wires and serpentine trusses.
• Mat wires are welded to a four-wire truss assembly at front and rear of shelf. Front and rear four-wire truss assembly is constructed of a 2 gauge (.250" diameter) bottom wire, a 6 gauge (.187" diameter) serpentine truss wire which creates a bridge-like reinforcement providing increased strength, and two 6 gauge (.187" diameter) top wires one directly below mat wires and one directly above which provide a pincer hold on mat wires.
• Top mat assembly is supported on each end by a three-wire truss assembly consisting of a 2 gauge (.250" diameter) bottom wire, a 6 gauge (.187" diameter) serpentine truss, and one 6 gauge (.187" diameter) top wire.
• Entire wire mat and truss assembly is notched at outside corners to accept a 12 gauge conical shaped collar, 1-5⁄8" in height which is welded in place.
• Conical-shaped collar is designed to accept a tapered ABS plastic split sleeve, or aluminum split sleeve, which clips over 16 gauge, 1"-diameter steel grooved post.
• Wire shelf and post are epoxy coated with applicable finish as specified and constructed in accordance with the National Sanitation Foundation (NSF) standards and bear its seal of approval.
• Wire shelf as specified will be QuadTruss® design as manufactured by EAGLE shelving, Clayton, DE.
• Epoxy finish complies with NSF Standards for use in all conditions ideal for low-temperature freezing rooms.