Mini Rotating Rack Convection Oven - Electric

Mini Rotating Rack Convection Oven - Electric
47.91"H x 37.49"D x 48"W

Features
• Rotating interior rack
- 8 pan, end load, with 4" slide opening
• Self-contained steam system
• Programmable digital control
-Four stage baking
(time, temp, fan delay & vent)
-Auto on/off
-Auto vent
-99 programmable menus
• Easy to open independent doors
• Over-sized viewing window in each door
• Stainless steel construction

Utilities
• Water Connect Point: 1/2" pipe size. Cold water @30-75 psi. minimum @ 1.2 G.P.M. flow rate.
• Drain Fitting: 1/2" NPT. Route to air-gap drain
• Vent: Type 1 hood may be required for baking vapors. Consult local code.
• Power Input
- Heating Circuit 208V/3/50A
- Control Circuit 120V/1PH
• Oven Control: 4.4 amps
• Ventilator Connect Point: 5.0 amps max.

Installation
• Level floor required.
• The mini-rack oven is shipped assembled for easy installaion. All components are factory tested before shipment.
• The purchaser is responsible for proper installation. In order to validate the warranty, the start-up must be performed by an Authorized Baxter Servicer. This start-up will be done at no additional charge.
• The OV300 unit will fit through a standard 36" doorway with doors, control panel and trim package removed.
• Certified for zero clearance to combustible surfaces, sides and back. Access to right side needed (24" min.) for service access. A vent guard is required if the right side of the oven is within 30" of a radiant heat or grease vapor source.