EAGLEbrite® Wire Shelving-14 x 54- Zinc

EAGLEbrite® Wire Shelving, 14"W x 54"L, zinc finish
• Assembly numerically calibrated grooved posts, tapered plastic split sleeves and shelf collars combine to make shelving assembly a simple two-step exercise:
1) snap the split sleeves onto a post over the number of your choice; and
2)slide a shelf collar over the split sleeves. A positive lock between shelf and post is created without the use
of any tools.
• Open-wire construction promotes higher visibility, allows light to pass through the shelves, permits greater air circulation which helps reduce moisture and dust build-up, and increases the effectiveness of fire-suppression systems.
• Tapered split sleeves of high-temperature-resistant ABS plastic create a positive lock that becomes stronger as the load increases.
• Posts are numbered in increments of 1 (25mm) to ensure fast and level assembly.
• Leveling feet are provided to help compensate for uneven floor surfaces.
• Shelf strength the mat on an EAGLE shelf utilizes a pincer-type design with the mat wire sandwiched between the two top truss wires, adding significant strength and distributing the entire load without stress and strain on the welds

• Wire shelf, constructed of carbon steel or type 304 stainless steel wire, consists of a top mat assembly using 10 gauge (.135diameter) mat wires spaced on 7⁄8 centers and welded to full length 6 gauge (.187 diameter) inside support wires and serpentine trusses. Quantities of each are based on shelf size. Mat wires are welded to a four-wire truss assembly at front and rear of shelf. Front and rear four-wire truss assembly is constructed of a 2 gauge (.250diameter) bottom wire, a 6 gauge (.187 diameter) serpentine truss wire which creates a bridge-like reinforcement providing increased strength, and two 6 gauge (.187 diameter) top wires one directly below mat wires and one directly above which provide a pincer hold on mat wires.
• Top mat assembly is supported on each end by a three-wire truss assembly consisting of a 2 gauge (.250 diameter) bottom wire, a 6 gauge (.187 diameter) serpentine truss, and one 6 gauge (.187 diameter) top wire.
• Entire wire mat and truss assembly is notched at outside corners to accept a 12 gauge conical shaped collar, 15⁄8 in height which is welded in place. Conical-shaped collar is designed to accept a tapered ABS plastic split sleeve, or aluminum split sleeve, which clips over 16 gauge, 1-diameter steel grooved post.
• Wire shelf and post are either plated or epoxy coated with applicable finish as specified and constructed in accordance with the National Sanitation Foundation (NSF) standards and bear its seal of approval.
• Wire shelf as specified will be QuadTruss® design as manufactured

by EAGLE shelving, Clayton, DE.