Eagle Group 1 Comp Sink w/ Double Drainboards

EAGLE ™ Galvanized S/S One Compartment Sink With Backsplash and Double Drainboard

Design and Construction Features:
• All bowls have deep-drawn one-piece seamless construction using state-of-the-art hydraulic presses.
• Drainboards, when provided, are integrally welded.
• All sink bowls have a generous radius with a minimum dimension of 3 (76mm) and are rectangular for
maximum capacity.
• Leg locations are adjacent to sink bowls, providing increased stability and maximum weight support
where needed.
• Leg gussets welded to a die-cut heavy-gauge reinforcing plate.
• Entire assembly is fuse-welded and planished providing a one-piece seamless sink unit.
• Welded areas are high-speed belt blended to match adjacent surfaces with continuity of satin finish.
• 10 (248mm)-high full length standard backsplash features 1 (25mm) upturn and tile edge for easy
installation and feathering to wall/splash surface.
• All outside corners of sink assembly are bullnosed to provide safe, clean edges.
• 14 (356mm) water level 17 (432mm) flood level.

Mechanical:
• Water supply is 1⁄2 (13mm) IPS for hot and cold lines.
• Faucet holes are 11⁄8 (29mm) punched on 8 (203mm) centers; two sets of faucet holes are
punched where indicated on schedule.
• Faucets are available as options.
• Basket-type waste drains included fit sink bowls
1⁄2 (89mm) opening and feature 11⁄2 (38mm) outlet.

NSF-approved installations:
All EAGLE™ sinks bearing the NSF Certification Mark are built in compliance with the National Sanitation
Foundation Standard Number 2.

• 14 (356mm) water level is standard.
• Heavy gauge stainless steel construction bowls are type 304; drainboards and backsplash are type 430.
• Deep-drawn seamless coved corner bowls.
• Swirl-away drainage.
• Legs welded adjacent to sink bowls for maximum weight support and stability.
• 10 (254mm) standard backsplash includes 1 (25mm) upturn and tile edge for easy installation and feathering to wall/splash surface.
• Adjustable non-corrosive bullet feet.
• Die-stamped creased drainboards for positive drainage.

Material:
Sink Bowl Heavy gauge type 304 stainless steel.
Top Drainboards, backsplash and rolled rims are heavy gauge type 430 stainless steel.
Legs 15⁄8 (41mm)-diameter heavy-gauge galvanized tubing with plated 12-gauge gussets and high-impact corrosion resistant fully adjustable bullet feet crossbracing is 1 (25mm)-diameter heavy-gauge galvanized tubing.

Dimensions:
31" x 74" (787 X 1880 mm) width/length
24" (610mm) Drainboard Length
24" X 24" (610 x 610mm) Bowl Size