Atlas Metal Cold Food Drop-In Unit

Cold Food Drop-In Unit - 4 Pan Size - 9.2 Amps 120 V

DESCRIPTION:
The WCM-BT series cold pan is the most efficient refrigerated cold food display available anywhere. The traditional cold-wall system is replaced by a forced air evaporator, enabling precise temperature control and maximum cold transfer to your food product. The drop-in pan can be installed in virtually any counter and can be provided as fully self-contained - just plug it in and turn it on.
The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory applied gasket so that is can be installed in the finest wood fixtures without marring the counter top. The pan is constructed of stainless steel and is provided with a 3/4" stainless steel drain. The forced air evaporator drains into a condensate evaporator.

FEATURES:
• Forced air evaporator blower system for maximum efficiency in cooling - more consistent food product temperature
• Automatic Defrost System
• Fully insulated for energy savings
• Factory applied gasket - makes installation a snap and seals units to the counter top, thus eliminating seepage
• Stainless steel adapter bars
• UL recognized

TOP: Constructed of 18 gauge, type 304 stainless steel, die stamped with a raised perimeter bead. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing
seepage or marring of the counter top. Embossed mounting lugs are provided along the inner surface of the top to hold the removable adapter bars in place. A full set of adapter bars is provided.

LINER: The inner liner shall be 18 gauge, type 304 stainless steel with 3" recessed top, one piece construction, all welded, ground and polished to a uniform finish. All corners are coved with a minimum 1/4" radius. The liner has copper tubing firmly soldered to the exterior bottom and all sides. A 3/4" dia. drain with strainer, 4" PVC nipple, and valve is provided.

INSULATION: The pan is fully insulated with high density polystyrene, 1" thick on all sides, 2" thick on the bottom and enclosed with a 22 gauge galvanized steel outer lines. The entire unit is removable with-out the use of tools.

REFRIGERATION SYSTEM: The compressor housing shall be fabricated from 14 gauge galvanized and bolted to the base of the unit. A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control. The system is also provided with a forced air evaporator for even temperature throughout the pan, and drains into a condensate evaporator pre-wired in the unit. The system is fully charged with CFC free refrigerant and ready to operate.

NOTE: Proper ventilation must be provided in counter.

ELECTRICAL: (WF series only) The unit will be wired for 15 amps., 120 volt, single phase operation with an on/off thermostat switch and pilot light. A 6' long, 3-wire cord and plug (NEMA 5-15P) will be provided.

***IMAGE DISPLAYS SIMILAR ITEM - NOT THE ITEM ITSELF***